Select Page

Ethernet Config – Shark 200

by | Nov 5, 2017 | certified-example-group, Power Meters Shark-Group

Pulse Meter Inputs from Revenue and Sub-Meters
SHARK Eth

Configure a Shark 200 using the available Ethernet port

Note the Shark 100 with an Ethernet port is basically the same procedure.

Install Ethernet card in rear slot of Shark 200

Conn Mgr

Install Communicator Ext from Manufacturer’s CD or download from website and run.

Select Connection Manager

Add Loc
Select Add
Loc Edit
  1. Select Network
  2.  Host is the Shark 200 IP Address (10.0.0.2 is default from factory)
  3. The Shark 100 IP Address (10.0.0.1 is default from factory)
  4. Network port is 502
Edit Device
  1. Select Edit Current Device Profile
Configure

Select Network/IP Address and DNS

Configure as needed