Select Page

Set your PC Static IP Address (W7)

by | Feb 26, 2017 | IPm General Configuration-Group, Networking-Group

If you are connecting to an Ethernet device which has a static IP address then you must configure your PC NIC (Network Interface Card) to operate on the same network IP in order to attain a peer to peer connection.

Open the Control Panel

Click on Start and browse the “Control Panel” menu item

Network & Sharing if you view by large or small icons

View Network Status and Tasks if you view by Category

Click Change Adapter Settings

 

Select Local Area Connection

 

Select Open Properties

Highlight Internet Protocol Version 4 (TCP/IPv4)

Click Properties

 

Select “Use the following IP address” and fill in the blank fields with the information below:

This example is for a SN or RAM with a default IP Address of 192.168.0.1

IP address: 192.168.0.2
Subnet mask: 255.255.255.0
Default gateway: 192.168.0.1