by Marketing | Jul 11, 2024 | Configuration Advanced IPm-Group, GRIDlink 113-135 Configuration, Software Load 113 135 - Group, Trouble Shooting GRIDview-Group
Change sxClient / GRIDview – Telnet Changing the GRIDview sxClient via Telnet is a relatively simple procedure. This procedure is for GRIDlinks which have been pointed to a different server and now wish to switch. Load Software Connect via Ethernet If the...
by Marketing | Jul 9, 2024 | Trouble Shooting 113 135 Series-Group, Trouble Shooting Open ADR 2.0b-Group
Cycle Power It may become necessary to cycle the power to a GRIDlink to re-establish a network connection to the Utility ADR Server or GRIDview. Most common reasons are changes made to the network and the GRIDlink is unable to get an IP Address. It is important to...
by Marketing | Jan 11, 2024 | Trouble Shooting E-CE Series, Trouble Shooting E2-Group
Modbus Transfer Fails to Remote IO Trouble Shooting Problem: Modbus TCP Transfers to Remote IO connected on Ethernet ports 1 through 4 fail. Solution: These ports are set up an a DHCP Server and will communicate with Remote IO having a static IP. Make sure they have...
by Marketing | Jan 11, 2024 | Trouble Shooting E-CE Series, Trouble Shooting E2-Group
Fails to Come Online with GRIDview Trouble Shooting Problem: On a reboot the GRIDlink E Series does not come back Online with GRIDview. Solution: This is usually caused by the internal clock is out of sync. GRIDlinks will eventually sync with it’s configured...
by Marketing | Dec 8, 2023 | Crimson Software-Group
Crimson 3.2 – Connect to PC Crimson 3.2 – FlexEdge® controllers, Graphite HMIs and Edge Controllers, DA10D, DA30D, CR3000 & CR1000 HMIs.Crimson 3.1 – CR3000 & CR1000 HMIs, Graphite® HMIs and Controllers, and E3 I/O™ modules.Crimson 3.0...