by Marketing | Dec 17, 2022 | Configuration Initial IPm-Group, Toolkit-Group
Assign Resources – Toolkit The number of registers assigned should be greater than the number used in the project. Configuring 113/135 Series Assign Resources … Configure station module > Advanced Cycle Time – All products Cycle time (ms) 5000...
by Marketing | Nov 21, 2022 | Configuration Initial IPm-Group, Networking-Group, Toolkit-Group
Set Ethernet Port to DHCP – Toolkit The standard Ethernet configuration from the factory is DHCP. Configuring 113/135 Series Configure station module > ports > network 1/Eth0 > Use DHCP Configuration (Initial) for 113/135 Series Configure RS485...
by Marketing | Nov 21, 2022 | Configuration Initial IPm-Group, Toolkit-Group
Configure RS485 Serial Port for Modbus RTU The standard configuration for the RS485 port is to allow other Modbus serial devices to obtain data over Modbus Configuring 113/135 Series Configuration (Initial) for 113/135 Series Configure RS485 Serial Port for Modbus...
by engineering | Apr 25, 2017 | Configuration Initial IPm-Group, Toolkit-Group
Ethernet Connection – Toolkit Configuring 113/135 Series If you are unable to determine the GRIDlink IP Address then it is recommended to connect by serial cable using the DB9-RJ45 converter provided. See link If you wish to connect by Ethernet and do not know...
by engineering | Feb 26, 2017 | Configuration Initial IPm-Group, Configuration Tools IPm-Group, Toolkit-Group
Show DHCP Status – Toolkit The standard configuration is DHCP. This enables the user to determine what IP address was assigned to the unit. Configuring 113/135 Series 1. Open a Toolkit project and connect to the IPm via Serial Connection 2. Operations /...