by Marketing | Mar 27, 2023 | GRIDlink E CE Configuration, GRIDlink E2 Configuration, Power Meters Acuvim-group, Power Meters DENT-Group, Power Meters EMON-Group, Power Meters Shark-Group
Meter Data Transfer – E Series E Series configuration to obtain Modbus meter data via Ethernet. Communications Floating Point Modbus Registers User Defined Tags Automation > Tags Click on image to enlarge Modbus Registers 501-600 are reserved for up to 4...
by Marketing | Nov 9, 2017 | Power Meters Shark-Group
Specifications -Shark 100 vs 200 Meters 100 200 Frequency Range 0.01 Hz 0.03 Hz Frequency Accuracy 45-65 Hz 45-65 Hz Voltage Input Line to Neutral 416 576 Voltage Input Line to Line 721 721 Update Rate Watts-Var 100 ms 6 cycles Update Rate Frequency & all...
by Marketing | Nov 5, 2017 | Power Meters Shark-Group
Wiring – Shark Meters Shark 100 Manual Shark 200...
by Marketing | Nov 5, 2017 | Power Meters Shark-Group
Modbus I/O Transfers – Shark Meters GRIDlink can poll up to 4 meters of any type and can use Modbus RTU (RS485) or TCP over Ethernet The polls capture 15 Float Output Modbus registers starting from the Shark Modbus Address 40999 FI 500 Shark1_1 Volts A-N meter...
by Marketing | Nov 5, 2017 | Power Meters Shark-Group
Configure IP Address -Shark 100 Configuring the Ethernet IP Address requires the following process: Meters see Doc# E145704 V.1.08 Ethernet Programming (INP10 Option) Communication Wiring: The meter with Ethernet communication has an RJ45 port on its backplate. Use an...
by Marketing | Nov 5, 2017 | Power Meters Shark-Group
Ethernet Config – Shark 200 Pulse Meter Inputs from Revenue and Sub-Meters Meters Configure a Shark 200 using the available Ethernet port Note the Shark 100 with an Ethernet port is basically the same procedure. Install Ethernet card in rear slot of Shark 200...
